Electrical Engineering Fundamentals By Vincent Del Toro Pdf 🎯 Tested
Problem 9 — Practical measurement & instrumentation (15 pts) You must measure a small AC voltage (peak 20 mV) in presence of large common-mode interference (~10 V) using an instrumentation amplifier built from op-amps. a) (6 pts) Sketch the schematic conceptually (describe stages: input filtering, INA, gain, common-mode rejection). b) (5 pts) Choose an INA gain to get ~2 V full-scale output and compute resistor values or gain-setting component. c) (4 pts) List three practical techniques to maximize CMRR and reduce noise in this measurement.
Problem 8 — Digital electronics & interfacing (15 pts) Given a microcontroller GPIO pin with output high 3.3 V (max source 20 mA) driving an LED requiring 10 mA at 2.0 V forward voltage. a) (5 pts) Calculate the resistor value and nearest standard 5% resistor to use. b) (5 pts) If the LED must be driven at 40 mA, propose a simple transistor driver (specify transistor type, resistor calculations, and protection). c) (5 pts) Explain briefly why direct MCU driving at 40 mA is discouraged. electrical engineering fundamentals by vincent del toro pdf
Part D — Essay & synthesis (20 pts) Choose one of the two prompts (answer thoroughly, ~300–500 words): Problem 9 — Practical measurement & instrumentation (15
Problem 6 — Three-phase & power (12 pts) A balanced Y-connected load: Z_phase = 10∠30° Ω, supplied by a 208 V (line) three-phase system. a) (6 pts) Find phase and line currents (phasors) and per-phase real, reactive, and apparent power. b) (6 pts) If one phase goes open (unbalanced), describe qualitatively what happens to neutral current and load voltages. c) (4 pts) List three practical techniques to
Prompt B — Historical & conceptual reflection: Discuss how the transition from analog to digital signal processing changed circuit design priorities in power, bandwidth, and noise, citing specific examples (filters, amplifiers, communications receivers). Include one prediction for the next major shift in EE design over the next decade.
Problem 2 — Transient of RL network (15 pts) An inductor L=50 mH, resistor R=10 Ω, and a 5 V step source are connected in series. At t=0 switch closes. a) (7 pts) Derive i(t) for t≥0. b) (4 pts) Compute the energy stored in the inductor at t = τ (one time constant). c) (4 pts) Numerically evaluate i(t) and stored energy at t=τ. (Show numeric τ.)
Problem 4 — Resonant circuits & bandwidth (12 pts) A series RLC has R=20 Ω, L=100 μH, C chosen so resonant frequency fr = 1 MHz. a) (4 pts) Find C. b) (4 pts) Compute Q factor and bandwidth (BW). c) (4 pts) If R is halved, state qualitatively how fr, Q, and BW change.
